Letsevo

Project: DIY Skateboard

DIY Skateboard Database

DIY Instructions

Wednesday, 09 September 2009 03:00 Henrique Mattar Monnerat

Step by step:

Download Template from the project databasePrint the DesignTemplateLay the skate template prints in orderAlign the Letters, cut the templates on the dotted if necessaryIt is time to glueI don't know what say here, keep doing it.Template Ready! Find whatever you want to make a skateboard of... Time to build it, glue the design template on a sheet of material, in this case, I found a wood scrap and I am using a peace of old carpet as a griptape...Straight out of the band saw...Keep the design template to drill the holes Take the design template off, notice that the holes are not counter-sunk yet...softer woods require not counter-sinking...this wood was toughThis is what it looks like when you want the screws to counter-sink, on the board you can see the bit you normally use for achieving that

This is how the board looks likeTime for the griptape, use the board to mark your griptape designAfter cuting the Almost ready!After glueing the carpet griptape, I was ready to bolte the trucks.that's it!!! .........That's the HFG Offenbach on the background.........Enjoy!
Comments (0)Add Comment
feedSubscribe to this comment's feed

Write comment
smaller | bigger

busy
Last Updated ( Wednesday, 30 December 2009 17:43 )  
You are here: Home DIY Instructions