LETSEVO

Verison 0.1 Release Backlog:

Version 0.1 of the e.Moped is a 2D geometry template of the e.Moped, a CAD File for use in the next phases of the project. 

It shall contain the following geometries:

1. Wheel Size

2. Wheelbase

3. Seat height

4. Handlebar height and width

5. An indication of the riding position of Male and a Female body

Version 0.1 Sprint Backlog:

Sprint 01 

1. Compare the geometry a Motocross Motorbike and a Downhill Bicycle.

2. Define geometry guide lines based on the requirements on our e.Moped usage scenario: Lightweight MX, SUPERMOTO, ENDURO

Sprint 02

1. Analyse wheel standards

2. Build the 2D CAD template

Sprint 03

1. Analyse body measurements of a Tallest Male and Smallest female.

2. Translate it into two CAD drawings

Sprint 04

1. Fit body CAD drawings to moped measurements defined in Sprint one.

2. Check measurements

3. Generate a .DWG file and a .PDF

Time planing:

Release planned for Mid September of 2010

Comments on the project status are welcomed bellow or at the project's Forums.