| Table of content |
|---|
| Verison 0.1 Release Backlog: |
| Version 0.1 Sprint Backlog: |
| Time planing: |
Status: Sprint 01 - Towards Version 0.1
Verison 0.1 Release Backlog:
Version 0.1 of the e.Moped is a 2D geometry template of the e.Moped, a CAD File for use in the next phases of the project.
It shall contain the following geometries:
Wheel Size
Wheelbase
Seat height
Handlebar height and width
An indication of the riding position of Male and a Female body
Version 0.1 Sprint Backlog:
Sprint 01
Compare the geometry a Motocross Motorbike and a Downhill Bicycle.
Define geometry guide lines based on the requirements on our e.Moped usage scenario: Lightweight MX, SUPERMOTO, ENDURO
Sprint 02
Analyse wheel standards
Build the 2D CAD template
Sprint 03
Analyse body measurements of a Tallest Male and Smallest female.
Translate it into two CAD drawings
Sprint 04
Fit body CAD drawings to moped measurements defined in Sprint one.
Check measurements
Generate a .DWG file and a .PDF
Time planing:
Release planned for Mid September of 2010
Comments on the project status are welcomed bellow or at the project's Forums.
RSS feed Comments
Project Status